6 Most Common Problems with Massey Ferguson 240
The Massey Ferguson 240 tractor was introduced to the UK market in 1979.
A 2.5L 3-cyl diesel engine, 8 forward and 2 reverse gears, hydrostatic power steering, and a weight range of 4015 to 4585 pounds are all features of the Massey Ferguson 240 Tractor.
Overheating motor, diesel breakdown issues, steering wheel problems, electrical issues, dull blades, and leaking fuels are some of the most common issues.
I’ll go over the symptoms and treatments for these conditions. Continue reading to find out more about the challenges and concerns with the Massey Ferguson 240 tractor.
Problems and Solutions at a Glance:
| Problems with Massey Ferguson 240: | Solutions: |
| Overheating Motor | Regularly check the coolant level and clean the radiator |
| Diesel Breakdown | Periodically check and clean the filter |
| Steering Wheel Issues | Now and then, loosen the steering bearing |
| Electrical Issues | Examine the wires and the spots |
| Dull Blades | Sharpen the blades at least twice a year |
| Diesel Leaking | Check the oil level and If it is old enough to leak, replace it |
6 Most Common Problems with Massey Ferguson and Their Possible Solutions:
Now that you know about these issues, take a look at each of them and learn about the problems in detail.
1. Over-heating Motor
Radiator failures, coolant-related difficulties, insufficient engine oil, and faulty temperature indicators are all common causes of tractor overheating.
The engine temperature of the tractor should be between 150 and 180 degrees Fahrenheit. The temperature warning light will illuminate when the engine hits temperatures of at least 220 degrees Fahrenheit.
Look at the temperature gauge if the signal does not light. It’s possible that the coolant system isn’t operating properly and the engine is running hot if the needle is going towards the hotter end of the scale after only a few minutes of driving.
The Fix:
Because radiators are the source of the majority of issues associated with an overheated tractor, it is important to clean the radiator if it is dirty. Dirt can block airflow, causing the radiator to operate.
Allow the engine to cool down fully if there isn’t enough coolant in the radiator. Check for fluid by removing the radiator cap and monitoring the coolant levels once it has cooled.
If more is required, make sure you use the same type of coolant as is currently in the radiator.
2. Diesel Breakdown
The fuel filter is the first place to examine if your diesel tractor won’t start. The filter may be dusty, clogging the vents and preventing gasoline from reaching the engine from the tank.
The loss of vacuum to the fuel injection pump shut-off valve is the most common cause of your diesel engine failing to shut off. A leak anywhere in the lines is the most common cause of unexpected loss of vacuum.
Dead battery, clogged fuel filter or fuel lines, damaged or broken mechanical components, overheating engine, contaminated diesel fuel, and jammed fuel are the main symptoms of diesel breakdown.
The Fix:
If the problem is with the filter, remove it and clean it, or replace it entirely. This will almost certainly solve your issue.
Before purchasing a new battery, you should take your old one to a mechanic.
You should take your tractor to a professional mechanic if the issue is with the fuel injection pump. Working on the fuel injection system by yourself is tough. Attempting to fix it yourself might cost you more money in the long run.
3. Steering Wheel Issues
Sometimes the wheel seems too heavy, which significantly reduces flexibility.
This occurs as a result of an excessively tight steering bearing, severe main pin wear, an excessively wide gap between the nut and the ball pin, and inadequate lubricating oil consumption.
The wheel can occasionally become loose, which is dangerous. This happens if the steering wheel nut and ball pin have too much room between them, and the steering wheel has too much free motion.
The Fix:
To fix the steering wheel, the slipping issue can be resolved by lowering the thickness of the gasket.
Several of the possible fixes for the heavy wheel is to correctly loosen the steering bearing that is too tight and replace the main pin that is too worn out, and adjust the space between the nut and the ball pin.
You can repair the front axle support plate, the steering shaft, or both to solve the shaking problem. Be sure to pay attention to the quality of the screws and promptly tighten any loose components.
4. Electrical Issues
The majority of tractor electrical problems are caused by a faulty battery charge. So, if you have an electrical problem, the first thing you should examine is the battery charge.
When your equipment is left idle for a few weeks, the battery may get depleted.
The Fix:
To assist avoid buildup, you must clean the locations often ad recheck cables. You might need to see a tractor dealer for expert assistance if you’ve recharged and cleaned the battery but it’s still giving you problems.
Additionally, you should inspect the wires and supports to see if you can find any signs of wear or material deposits.
5. Dull Blades
The mower blades may be dull if they are not mowing grass effectively. The blades may deteriorate and get dull over time.
In addition to being ineffective, dull mower blades can occasionally even cause the mower to stall when grass winds around the blade, making it more difficult for the engine to move the crankshaft.
The Fix:
The blades can be improved in performance by sharpening them. You only need to go through this process twice a year, on average.
It can be sharpened using a file. If you are not skilled enough to remove the blade safely, you should go to a tractor repair shop for assistance.
6. Diesel Leaking
After turning off the engine, diesel fuel occasionally leaks. Most of the time, leaks do not occur when the tractor is operating.
Oil leaks can also be brought on by a leaky head gasket or sump gasket. A little hole in the gasoline tank is the cause of certain fuel leaks.
Because the gasoline tank rots, ages, or malfunctions over time, fuel leaks develop.
The Fix:
When the engine spills oil, check the oil level. If the engine appears to be overfilled with oil, drain it to the full mark on the dipstick.
The whole thank might need to be changed if the tank is old. A safe tank is far better than one that may catch fire.
What Majority of the Users Feel?
The Massey Ferguson 240 performs admirably. In the majority of forums, the rating is up to 4. Despite some concerns, some customers stated on Tractor By Net that the electrical and mechanical difficulties could be rectified.
Numerous users have reported that the tractor was still quite efficient even after being purchased and used. After operating the tractor, they are really satisfied with it and think this tractor is highly dependable.
Given the accessibility of replacement parts and the proper degree of power, it is clear why this tractor is a wise option. Due to its significant experience, Massey Ferguson is expected to remain in business for many years.
Frequently Asked Questions
What type of transmission is used in the Massey Ferguson 240?
An 8-speed sliding gear with 8 forward and 2 reverse gears is installed.
What is the coolant capacity of a Massey Ferguson 240 engine?
9.8 liters or 10.4 quarts.
When was Massey Ferguson 240 first manufactured?
The manufacturing started in 1979 and discontinued in 1999.
What is the price of the Massey Ferguson 240?
$7,800 to $7,900.
Final Thoughts
The problems with the Massey Ferguson 240 tractor can be easily fixed now that you are aware of them. Please keep in mind that a tractor has to have every component regularly repaired for it to function effectively.
Tractors are great pieces of equipment. No machine, however, is fault-free. Consider the Massey Ferguson 240 model, which is still quite popular among farmers despite all the problems.
You can use my suggestion if you encounter any of the problems. and you should always consult a professional if the problem is more serious.
Related Posts: